User Manual

Back to Contents Page
Getting Started with your Wireless USB Adapter:
Wireless USB Adapter User's Guide
To complete the setup of your Wireless USB Adapter, perform the following 3 steps:
1. Installing the software (drivers and Wireless Configuration Utility)
2. Connecting the device to the computer
3. Connecting to your wireless network
1. Installing the Software
a. Insert the Wireless USB 2.0 Adapter CD into the CD or DVD drive of your computer. If the
Main Menu screen does not appear automatically, select Start
→
Run and then type
x:\setup.exe (where x is your CD-ROM drive letter) and click OK.
b. Click on Install Software.
c. The wizard will install the Wireless Configuration Utility and the driver for your device.
Back to Top
2. Connecting the Wireless USB Adapter to Your Computer
a. Connect the small connector of the USB cable to the connector in the Wireless USB Adapter as
shown in Figure 1.
Figure 1
NOTE: If you did not purchase this device with a new system, please start at step 1.
If you purchased this device with a new system, please skip to step 2.
NOTE: This installation is required before connecting the device to the system.
Pa
g
e 1 of 4Gettin
g
Started with
y
our Dell™ Wireless USB Ada
p
ter: Dell™ Wireless USB Ada
p
ter User's G...
4/27/2005file://C:\Documents and Settin
g
s\Mark\M
y
Documents\Re
p
orts to review\J59313\submittal items
\
...