Installation Guide

Page8of9

Required Information to be documented in the Class I permissive
change report
A summary of the information to be included in the Class I permissive change report is listed
below. OEM integrators must consult the FCC KDB 616217 Supplement document for details.
1. FCC ID of all transmitters, maximum average conducted output power in each transmission
mode and frequency band, operating configurations and exposure conditions approved for
the individual transmitters.
2. Applicable antenna locations for all host configurations identified in diagrams, drawings
and/or photos, including the range of antenna-to-user and antenna-to-antenna separation
distances to support the required test reduction and exclusion analysis or SAR test
configurations (The closest distance between each antenna and the user and the closest
distance between individual antennas should be used.)
3. The type and physical dimensions of antennas incorporated in the intended host
configurations
4. Antenna gain specified by the antenna manufacturer for antennas qualified for mobile
exposure conditions
5. Other relevant information and restrictions required by the equipment certifications of
individual transmitters, including antenna changes
6. The range of applicable physical, mechanical and electrical variations of host computer
configurations supported by the test results in all relevant equipment certification.
Required Host System Labeling
FCCID and Industry Canada ID
The Integrator must affix the Atheros module’s FCCID on the module. Also, when the module is not visible when
installed in the host system, an additional label must appear on the outside of the host system visible to the user. Industry
Canada (IC) labeling is only required on the module.
Example FCC & Canada IDs to appear on module:
FCCID: PPD-ARS42
IC: 4104A-ARS42
Example wording also to appear somewhere on the outside of the host system visible to the end user:
Contains FCCID: PPD-ARS42
FCC Logo
The FCC logo shown below must appear on the host system signifying declared compliance of the system with FCC
digital emissions rules.

Required User Manual Wording for Host PC System
The FCC requires the following text (or equivalent) included in the user documentation provided to the end user:
Example text which can be used by the Integrator in the end user instructions are: