User's Manual

56 - Memory Upgrade Module
Memory Upgrade Module
Your Fujitsu MH380 notebook comes with 1GB of high speed Double Data Rate Synchronous Dynamic
RAM 2 (DDR2 SDRAM), 667 MHz factory installed. To ensure 100% compatibility, purchase the SDRAM
module only from the Fujitsu web store at www.shopfujitsu.com.
Removing Memory Modules
1 Turn off power to your notebook and remove any power adapter (AC or auto/airline).
2 Make sure that all the connector covers are closed.
3 Turn the system bottom side up, and remove the screws of the memory upgrade module compartment.
(Figure 13).
4 Remove the cover.
5 Pull the clips sideways away from each side of the memory upgrade module at the same time. (Figure 13)
6 While holding the clips out, remove the module from the slot by lifting it up and pulling towards the rear of your
notebook.
7 Store the memory module in a static guarded sleeve.
• DO NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE
ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY
UPGRADE MODULE
.
• THE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
(ESD). T
O MINIMIZE RISK TO THE MODULE, OBSERVE THE FOLLOWING PRECAUTIONS:
• BEFORE HANDLING A MEMORY MODULE, TOUCH A GROUNDED METAL OBJECT TO DISCHARGE
STATIC ELECTRICITY BUILT UP IN YOUR BODY
.
• WHEN INSTALLING OR REMOVING A MEMORY MODULE, HOLD IT BY THE EDGE SO AS NOT TO
TOUCH ANY CONTACTS OR CHIPS
. BE CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER
TERMINALS OR COMPONENTS
; THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE
COMPONENTS
.
• BE SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES.
E
VEN IF THE SYSTEM IS IN HIBERNATE OR SLEEP STATES, DATA COULD BE LOST OR THE MEMORY
COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
.