User Manual

Operation
MODELS MRCT-2 or Later Models
ID Code Set-Up – The ID code is the number transmitted, once each time, when the
MRCT transmit button is depressed. The ID code is set using the switches located on the
side of the transmitter. The numbers can be changed by pressing either the ‘+’ button
below or ‘-’ button above the displayed number. The number displayed in the switch
window will be the ID code transmitted.
Example: ID Code 34
1
st
switch = 3; 2
nd
switch = 4;
ID number 34 would be transmitted and displayed
on the MIDS Receiver/Monitor
NOTE: When switch ID’s 64-99 are transmitted they will
result in a received ID code of 63.
Transmit Button
MODELS MRCT & MRCT-1
ID Code Set-Up – The ID code is the number transmitted, once each time, when the
MRCT transmit button is depressed. The ID code transmitted must be determined based
on the table below. The ID code is set using the switches located on the side of the
transmitter. These switches are set by pressing either the ‘+’ button below or ‘-’ button
above the displayed number.
Example: ID Code 28
x8 switch = 3; x1 switch = 4;
= (8 x 3) + (1 x 4)
= 24 + 4 = 28
ID number 28 would be transmitted and displayed
x1 switch
x8 switch
on the MIDS Receiver/Monitor
Transmit Button
QTI Page 7 Revision: C
Form #: 30Z0147 Effective Date: 24 August 2006