User Manual
Table Of Contents
- Description
- Design Features
- Operation
- ID Switch Setting Chart
- Sensor Connection
- RF Link
- Emplacement Considerations
- Section 2:MIDS Remote Control Transmitter (MRCT)
- Frequency Range:138-174 MHz
- Section 3:MIDS Hand Held Receiver (MPDM)
- Section 4:MIDS Remote Control Receiver (MRCR)
- Pin Connector:A: Ground
- Section 5:Frequency/Channel Calculations
Section 4: MIDS Remote Control Receiver (MRCR)
Description
The MIDS Remote Control Receiver (MRCR) is used to provide a contact open/closure
upon receipt of a user specified ID. This provides a means to interface MIDS equipment
with user provided auxiliary equipment (camera, video, tape recorder, etc). An external
connector and cable assembly is provided for access to the relay contacts and to provide a
means for selecting the relay operating time. The relay operates for ½ second and can be
extended up to 5 seconds. For longer relay times an MSTR switch should be used in
conjunction with the MRCR.
Battery Cap
Test
Button
Antenna
Connecto
r
Auxiliary
Cable
Connector
ON/OFF
Channel: Factory Pre-Set Single Channel
Antenna: ¼ wave stub or ½ wave rod
Frequency Range: 138-174 MHz
Power Supply: 2 each 9 V DC Batteries
(MN1604)
Battery Life: 96+ hours with continuous
operation
Pin Connector: A: Ground
B: Power +9V
C: Capacitor
D: Relay Contact NO
E: Relay Contact Common
F: Relay Contact NC
Design Features
• Push button test
• Remote operation of external equipment
• 5 different cable choices
- Auxiliary equipment cable, flying leads, 10 feet
- Y-cable, 4-pin male connector and flying leads, 18 inches
- Y-cable, (2) 4-pin male NC/NO connectors, 18 inches
- Y-cable, (2) 4-pin male NC/NC connectors, 18 inches
- MSTR cable, 4-pin female connector, 5 feet
• Variable relay operating times
- From 0.5 to 5 seconds
- With MSTR: 0.25 seconds to 2 hours, switch setting
• Potted and sealed electronic components
• Injection molded lexan plastic housing
• Metal battery cap clamps with heat welded screw inserts
• Frequency matched antenna
QTI Page 11 Revision: C
Form #: 30Z0147 Effective Date: 24 August 2006