Instruction Manual

QTI Page 8 of 13 Revision: A
Form #: 30Z0250 Effective Date: 16 December 2009
Commands
?…….. Brings up the help menu
The current help menu (without checksums) appears as follows:
Commands
---------
HELP/?:
Show this menu
CHR:
Get/Set rcv Chan
CHX:
Get/Set xmit Chan
MSG:
Get rcvd msg
PWR:
Get/Set xmt pwr level
PSH:
Get/Set push mode
RCV:
Get/Set receive mode
RSS:
Get receive signal strength
RST:
Reset
SAV:
Save Current Parameters
SLP:
Sleep
SRN:
Get unit serial num
TMP:
Read Temp
TRS:
Turn TRSS Format On/Off
TXM:
Xmit msg, type, ID, stat
VER:
Show versions
CHR…Get/Set the receive channel. (Follow with SAV command.)
Low Band: 0-600
Med Band: 0-1600
High Band: 0-1920
Get the channel:
CHR<CR>
Returns:
CHR Z<CR>
Set the channel:
CHR Z<CR>
Returns:
CHR Z SET<CR>
Or CHR Z ERR<CR> if invalid value given
CHX…Get/Set the transmit channel. (Follow with SAV command.)
Low Band: 0-600
Med Band: 0-1600
High Band: 0-1920
Get the channel:
CHX<CR>
Returns:
CHX Z<CR>
Set the channel:
CHX Z<CR>
Returns:
CHX Z SET<CR>
Or CHX Z ERR<CR> if invalid value given
MSG….. Recall a previous message.
0-9 with 0 being most recent message, and 9 being the oldest message
Get a message:
MSG X<CR>
Returns:
RXM TT III SS<CR>, where TT is the message type,III is the ID, and
SS is the status code
NEW…..Read New messages. Use when PUSH is OFF. (This command is not listed under Help menu.)