Product Info

Software Specification
<Project name here>
Document Number 1193-30xx Page 18
This document contains confidential and proprietary information of Quake Global corporation. It may be used by recipient only for the purpose for which it was
transmitted and will be returned upon request or when no longer needed by recipient. Disclosure to unauthorized third parties or duplication without the express
written permission of Quake Global is prohibited. © 2022 QUAKE GLOBAL, INC. - All rights reserved
Confidential
Information classified Confidential
- Do not copy.
3)User Name: root
4)password:certs
If connection is failing type on TeraTerm serial: ifup - a
Return to ethernet window and repeat steps 1 and 2
5)type: ls
Preparation:
Make sure that wifiTest is available in the list of application installed by typing ‘ls’
If the device does not have the wifiTest file, please contact Quake Global.
The HPRO-4G will only be tested for the 2.4 GHz band, the following instructions are for continuous test:
This script should only be run once. Navigate to the ‘root’ directory (default location after login/pass). For general
transmit functions, from the # prompt:
Type the following:
o ./wifiTest inter
o start
o cOn
1. Enter “cCh X Y Z” where X is the channel, Y is the band, Z is the bandwidth [SEE EXAMPLE BELOW FOR
REFERENCE]
a. For the selection of low/mid/high channels, type the bolded text below:
To select Low Channel: cCh 1 0 0
To select Mid Channel: cCh 6 0 0
To select High Channel: cCh 11 0 0
2. Enter “cPow X Y” where X is the power set, Y is for the antenna selection, range is 0-3, 0 is Auto, 1 for
Ant1,2 for Ant2 and 3 for both.
a. This only needs to be configured once, the power range is in 0-20000 where 20000 is 20 dBm,
for this setting go use the command:
i. cPow 16500 0
3. Enter “cTxOn X Y” where X is the rate 11b/g/n and Y is the BW (20 or 40 MHz)
a. Lowest setting for 2.4 GHz band is 11b 1 MBPS
i. cTxOn 0 0
4. Enter “cTxOff” to turn off the transmitter.
To setup for next configuration: Return to step 1
To change channels: Go to step 1 then skip to step 3 to transmit, if power output is to remain the same.