User Manual Part 6
User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 157
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
Appendix D - Debug and utility menus
QUAKE Global provides a large group of debug and utility menus which are accessible via the
Logger port. These menus allow the user to send and receive messages and email, view
operational performance, conduct serial tests and many more functions. Some of the menus
require a password and are accessible to QUAKE personnel only. The menus are accessible
from the Logger port using the following settings:
Baud rate: 115200 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Two different commands can be used to enter the menus, either ‘d’ (debug) or ‘U’ (utility). Each
command will display a listing of debug or utility menus respectively. Each menu can be entered
by typing the corresponding letter code in the list. The list of letter codes for either menu can be
displayed by typing ‘?’. For example, ‘d’ ‘?’ gives the list of letter codes (commands) for all the
debug menus listed under ‘d’.
Figure E-1: Debug menus available from ‘d’ ‘?’