User Manual Part 5

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 98
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
12.4.3 DemoAppREMOTE
This application demonstrates sending remote messages via GSM/GPRS and POP email to the
modem and the proper evaluation and operation of these message events. Message events
include sending an email to the modem, setting a relay, and remotely downloading a file to the
modem. In this example, you must have at least one valid email address for your modem. Note
that this sample application uses network-specific calls.
1. Select the DemoAppREMOTE Workspace from the drop-down list at the top, left-hand corner
of the IAR IDE screen. Open the APL.c file, as shown below:
Figure 12-35: DemoAppREMOTE - Selecting the Workspace
2. Now build, load and execute DemoAppREMOTE. The instructions for building, loading and
executing the code are the same as in Section 12, except that after building the application,
the executable bin file is: …/DemoAppREMOTE/exe/xxx-DemoAppREMOTE.bin .
3. After startup, check the Logger output for the line APL DEMO: Remote Control. This
indicates that the correct DemoApp is running.