User Manual Part 5

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 108
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
1. To run the CAN/J1939 example, select the DemoAppCAN Workspace from the drop-down
list at the top, left-hand corner of the IAR IDE screen. Open the APL.c file, as shown below:
Figure 12-45: DemoAppCAN - Selecting the Workspace
2. Now build, load and execute DemoAppCAN. The instructions for building, loading and
executing the code are the same as in Section 12, except that after building the application,
the executable bin file is: …/DemoAppCAN/exe/xxx-DemoAppCAN.bin .
3. After startup, check the Logger output for the line APL DEMO: CAN/J1939. This indicates
that the correct DemoApp is running.