User Manual Part 4

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 90
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
The AUX port
• maximum speed is 57600 bps.
• may not be available on certain configurations of the Q4000/QPRO. The
Q4000/QPRO with Iridium or Inmarsat, for example, does not have the AUX port
available.
12.4.2 DemoAppSERIAL
This sample application demonstrates some of the Q4000/QPRO’s serial port and multitasking
functionality. DemoAppSerial may be used with either the AUX port, or the MTS or Logger port.
It is necessary to use a different method with the AUX port than with the MTS or Logger port.
DemoAppSerial first shows the use of the AUX port to send data. Note that this sample
application uses network-specific calls.
1. Select the DemoAppSERIAL Workspace from the drop-down list at the top, left-hand corner
of the IAR IDE screen. Open the APL.c file, as shown below:
Figure 12-27: DemoAppSERIAL - Selecting the Workspace
Note: