User Manual Part 2

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 58
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
It is important to put the modem’s SMS number on a DO NOT CALL list to avoid
receiving spam mails.
9.1.3 GSM/GPRS
Email to a modem using GSM/GPRS has an address specified by the configuration parameters
and the network being used. For example, with the configuration parameters shown below, an
email from the gmx.com server to a modem would have the format [e-mail].
Table 9-1: SMTP and POP configuration parameters
Name
Value (Hex)
Sample Values
QCFG_MODEM_APN_ADDRESS 0x9D orbcomm.t-mobile.com
QCFG_SMTP_USER 0xA6 [e-mail]
QCFG_SMTP_PASS 0xA7 Password
QCFG_POP_USER 0xAC [e-mail]
QCFG_POP_PASS 0xAD Password
QCFG_SMTP_SERVER_ADDR 0xA4 mail.gmx.com
QCFG_POP_SERVER_ADDR 0xAA pop.gmx.com
QCFG_SMTP_TO_ADDR 0xA8 [e-mail]
QCFG_SMTP_SUBJ 0xA9 This is a test subject…
9.2 Sending SMS messages to the modem
SMS messages may be sent to the modem from the GPRS/GSM network. To determine the
SMS number of a modem, it is necessary to send the command TERR_getInfo () after the
GPRS/GSM module has been powered on. The format of the TERR_getInfo command is
described in the Application Programming Interface (API). The parameter to the command must
be REQ_INFO_TERR_SMS_NUMBER .
Note: