User Manual Part 2

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 49
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
8 Installing the IAR Integrated Development Environment
Code for the Q4000/QPRO modem is developed on the IAR Systems Embedded Workbench.
This is a fully Integrated Development Environment (IDE) containing an optimized C compiler,
assembler, linker, text editor and associated tools. QUAKE software follows open industry
standards whenever possible to allow existing ‘C’ code to port over easily.
If you have purchased a Development Kit from QUAKE you will be provided with a temporary
license key for the IAR IDE. Included with the installation material is the IAR dongle shown
below. It is not necessary to have this plugged in during the following installation.
Figure 8-1: IAR dongle
Follow these steps to install the IAR workbench :
Install the software using the CD that was provided. IAR provided a “welcome letter” with the
package. On that “welcome letter” there is a license number and a quickstart key. Both of these
are needed in order to complete the initial installation.
1. Select the application, and then unzip the files.
Figure 8-2: IAR zip file contents screen