User Manual Part 2

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 43
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
7.2 QUAKE Configuration Parameters (QCFG)
QUAKE uses parameters 0x80 – 0xFF. All these parameters have “QCFG_” as a prefix. For a
complete list of the QCFG parameters, see Appendix B - QUAKE’s ORBCOMM configuration
parms (QCFG) and Appendix C - QUAKE’s Iridium & Inmarsat config parms (QCFG). There are
several ways to modify QCFG parameters. They can be modified via:
• debug menus on the Logger port
• QCP protocol on the MTS port
• API calls made by a user’s application.
To view the current values of the QCFG parameters from the Logger port, connect a Terminal
Emulation program to the Logger port with the following settings:
Baud rate: 115200 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None.