User Manual Part 1

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 23
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
QUAKE Turnkey APL Version Apr 1 2011, 15:16:20
Turnkey parameters may be set using the CfgMgr Utils (type U C M to
access)
Parameter names and current settings are:
TK_POWER_DOWN_AFTER_MSG 0
TK_XMIT_INTERVAL 60
TK_RX_INTERVAL 0
TK_PARAM_MASK 0xffffffff
TK_POWER_DOWN_GSM_AFTER_MSG 0
TK_ENABLE 1
TK_PGN0_NUMBER 65263
TK: ORBCOMM Modem Startup
TK: TERR Modem Startup
---accessPointName = orbcomm.t-mobile.com
---serverName = mail.gmx.com
---serverPort = 25
---smtpUser = [e-mail]
---smtpPass = Quaketest11
---smtpToAddress = [e-mail]
---smtpDefaultSubject = Testing
---accessPointName = orbcomm.t-mobile.com
---popServerName = pop.gmx.com
---popServerPort = 110
---popUser = [e-mail]
---popPass =
TIMER_set: Timer 0 (timerType VOLATILE) Duration 60 Secs
TIMER_set: Timer 3 (timerType VOLATILE) Duration 360 Secs
2.6.6.2 Turnkey messages during transmission
Below is an example of a Turnkey message sent over GSM/GPRS (terrestrial network). For more
information on Logger messages, see Chapter 5.
APL: TX Interval Timer - Sending message
No new GPS data
msg 1)len = 38: 0 0 0 0 97 CC D0 3A 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 4D D 0 0 3D D 0 0 0 0
Sending TKMsg from TERR!!!
2.7 Provisioning and activation
Upon receipt of the Q4000/QPRO, it is necessary to activate and provision the GSM/GPRS
service and/or the satellite service before using the modem to transmit messages.
• GSM/GPRS customers must obtain a SIM card from their carrier and place it into the SIM
slot located on the side of the Q4000. See Section 2.1.1.1 on how to install the SIM card.
• QPRO customers: the SIM card is installed at the factory and is inaccessible after that.
The customer may provide un-activated SIM cards to QUAKE during production and
activate them with their cellular provider upon deployment.