User Manual Part 1

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 20
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
2.6.3.2 Setting foundation (QCFG_) parameters
The Logger port can be used to change the preferred network designation and also to set the
SMTP and POP addresses.
1. Connect a Terminal Emulation program to the Logger port with the following settings:
Baud rate: 115200 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
2. Type the letters: ‘U’ ‘C’ ‘s’.
3. At the prompts, type the parameter’s value in hex from Table 2-3, and then the new value.
4. The new values must be written to flash and the modem must be rebooted to save these new
values. To do this, type ‘d’ ‘R’.
5. After rebooting, Turnkey will use the new configuration parameter values.
For more information on the foundation configuration parameters, see Chapter 7 - Configuration
parameters.