User Manual Part 1

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 18
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
The SMTP and POP parameters must have been previously configured over the MTS if
using GSM/GPRS.
The following data will be displayed:
+qkeca: TK_POWER_DOWN_AFTER_MSG=0
+qkeca: TK_XMIT_INTERVAL=60
+qkeca: TK_RX_INTERVAL=0
+qkeca: TK_PARAM_MASK=4294967295
+qkeca: TK_POWER_DOWN_GSM_AFTER_MSG=0
+qkeca: TK_ENABLE=1
+qkeca: TK_PGN0_NUMBER=65263
2.6.3.1.2 Via Over the Air (OTA)
It is possible to update the Turnkey parameters by sending an email or satellite message to the
modem. The parameters can be in any order and any number of them may be updated at a time.
2.6.3.1.2.1 Sending OTA parameters via ORBCOMM
To send OTA Turnkey parameters via ORBCOMM, the “TO:” address must be in the format:
[e-mail]. The subject line of the message can be anything. The body of the
email must have the following format:
Figure 2-13: Sending OTA Turnkey parameters via ORBCOMM
2.6.3.1.2.2 Sending OTA parameters via Iridium
To send OTA Turnkey Parameters via Iridium, the “TO:” address is [e-mail]. The
subject line of the message must be the IMEI number of the modem. You must use an
Note: