User Manual Part 1

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 15
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
All parameters used by Turnkey (TK_ and QCFG_) may be changed whether Turnkey is
running or not. However, Turnkey must be restarted for the parameter change to take
effect.
2.6.2 Parameters used by Turnkey: (TK_) and (QCFG_)
The Turnkey application uses two different types of parameters: (TK_) and (QCFG_).
The parameters unique to the Turnkey application (TK_) are defaulted to send a message every
ten minutes. The default message will contain the current time, the GPS location, the value of the
Digital I/Os (DIOs) and analog inputs, and Parameter Group Number (PGN) information for PGN
65253. By default, the message is attempted over the GSM/GPRS network first. If that is not
successful (or available), the application sends the message over satellite (depending on the
modem type).
Turnkey also uses several QUAKE foundation configuration (QCFG_) parameters which specify
the preferred network and SMTP and POP address information (if GSM/GPRS is used).
2.6.2.1 (TK_): Parameters unique to the Turnkey application
Table 2-1: Turnkey application parameters
Name
Description
Default
Value
Config
Type
TK_POWER_DOWN_AFTER_MSG
After Turnkey message is successfully
sent,
Power down modem = 1
Stay awake = 0
0 UINT8
TK_XMIT_INTERVAL
Time in seconds between successive
messages sent from modem over
GSM/GPRS or satellite.
600 UINT32
TK_RX_INTERVAL
Time in seconds between successive
message receive attempts over
GSM/GPRS.
Set to 0 to disable unsolicited POP
messages.
0 UINT32
TK_PARAM_MASK
Turnkey Parameter Mask, which controls
the fields of data included in the message
to transmit (shown in more detail below).
0xFFFFFFFF UINT32
TK_POWER_DOWN_GSM_AFTER_MSG
After Turnkey message is successfully
sent,
Power down GSM/GPRS = 1,
Do not power down = 0.
0 UINT8
TK_ENABLE
Enable Turnkey Application = 1, Disable
Turnkey Application = 0
1 UINT8
TK_PGN0_NUMBER
PGN for desired J1939 message 65253 UINT16
Note: