User Manual Part 1

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 14
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
See Appendix E - Software file naming convention for the key to the file names.
included or excluded in the message by setting bits in the message mask, but it is not possible to
add additional fields..
Turnkey can be used by customers who need a basic tracking or monitoring system. The
application requires only the configuration of message and transmission parameters in order to
run. This allows customers to use the Q4000/QPRO as an ‘out of the box’ solution.
If you have purchased an Evaluation Kit or Development Kit from QUAKE, the foundation code
and application code for Turnkey will already be installed on the modem. If not, or if you wish to
reload the modem, perform the steps in Section 2.4.
2.6.1 Downloading Turnkey application code
1. Download the latest Turnkey .bin file from the QUAKE website. After unzipping the file,
you should have a Turnkey file with the name format of Q4Ka-xGT-x.x.x.x-TurnKey.bin.
2. On the QCT screen, select Flash Æ
ÆÆ
ÆLoad Application.
A new screen will open for the application file’s address.
3. After entering the address, select .
For more information on QCT and downloading the application, see Section 12.2.2.