User Manual Part 1

User Guide to Q4000/QPRO
Document Number 1135-4713 Rev G
THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF QUAKE GLOBAL CORPORATION. IT MAY BE USED BY
RECIPIENT ONLY FOR THE PURPOSE FOR WHICH IT WAS TRANSMITTED AND WILL BE RETURNED UPON REQUEST OR WHEN NO LONGER NEEDED
BY RECIPIENT. DISCLOSURE TO UNAUTHORIZED THIRD PARTIES OR DUPLICATION WITHOUT THE EXPRESS WRITTEN PERMISSION OF QUAKE
GLOBAL IS PROHIBITED.
Page 11
CONFIDENTIAL
Information classified Confidential
-
Do not copy (See last page for obligations)
See Appendix E - Software file naming convention for the key to the file names.
2.4.1 QUAKE Configuration Tool (QCT)
The QUAKE Configuration Tool (QCT) provides a Graphical User Interface (GUI) to download
code and modify configuration parameters in the modem. QCT is available on the Downloads
page on the QUAKE website.
To download code or modify configuration parameters, load and run QCT on a PC connected to
the modem’s MTS serial port. When connecting to the MTS port, the default settings are:
Baud rate: 4800 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Figure 2-8: QCT – Initial screen
2.4.1.1 Downloading foundation code
If it is necessary to update the foundation (firmware) code, download the zip file from the QUAKE
Global website. After unzipping the file, you should have a foundation file with the name format of
Q4Kf-xGT-n.n.nnnn.nnn-ENC.bin.
1. In QCT, select Flash Æ
ÆÆ
ÆLoad Firmware
Figure 2-9: QCT – Update the firmware (1)
Note: