Data Sheet

QPRO Technical Data Sheet
Document 1137-0901, REV K 14
2.5 Connector Information
The tables below describes the different connector types used on the QPRO over satellite and GPRS
networks.
Table 2-3, QPRO Connector Types
Product
QPRO Sat
Connect
Sat Antenna
Connect
QPRO GPS
Connect
GPS Antenna
Connect
QPRO
GSM
Connect
GSM
Antenna
Connect
QPRO
SAT/GPS/Cellular
TNC-Jack
(Female
Contact)
TNC-Plug
(Male Contact)
Reverse
Polarity TNC-
Jack (Male
Contact)
Reverse
Polarity TNC-
Plug (Female
Contact)
SMA-
Female
SMA-
Male
Table 2-4, 35-Pin Connector Information
Interface
OEM Module
Customer Interface
Locking Tyco 1-776163-1 Tyco 776164-1
Pins - Tyco 770520-3
Crimping Tool - Tyco Hand tool 58440-1
If the 3.3 V Continuous Output Power pins are not being used, do not lead wires out of connector.
Connecting these pins to an external supply will damage the modem and void the warranty. The 3.3 volts are
supplied for external GPS modules. These voltages are fed from the same supply inside the Q4000 for the
digital section. If they are not used, they should be left out of the connector for the safety of the unit. If you
hook either of these supplies to, for example, VBATT by accident, the unit would be damaged.
If any of the R/F connectors are not being used, they MUST be water-tight sealed.
Information classified Confidential
-
Do not copy (See l
ast page for obligations)