Data Sheet

Q4000 Technical Data Sheet
Document 1135-0902, REV K 28
o SAEJ1455 vibration requirements.
Certifications 5.3
• Orbcomm Type Approval Pending
• Iridium Certification pending
• FCC
• CE
• J1455 – Note: Please see environmental considerations for Cyclic Humidity
• J1939 compliance
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
Including interference that may cause undesired
operation.
Note: Any changes or modifications to the QPRO product could avoid the final operation of equipment and
will void Quake Global’s warranty.
FCC IDs 5.3.1
One of the following FCC ID’s will apply, depending on the modem network type (see standard modem
configurations for details on which part numbers contain which approvals):
• iSatData Pro/Inmarsat Approval (TBD)
• Iridium FCC ID: PB596XXCS
• Orbcomm TAT ID: 819QWI
• GSM FCC ID: RI7GE865.
FCC Part 15 Class B - Radio Frequency Interference (RFI) (FCC 15.105) 5.3.2
This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to
Part 15, Subpart B of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential environment. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
Information classified Confidential
-
Do not
copy (See last page for obligations)