User's Manual

Download the Tend Baby app to

your iOS or Android device.

Find the perfect spot for your new

Kodak Baby Monitoring System &

plug it into an outlet using the

enclosed power adapter.

Press the power button on the right

side of the Base Unit to turn it on.

You’ll hear “power on”.

Wait up to two minutes for the

camera to go into setup mode.

When ready, the LED lights on

the right side of the Camera will

blink and alternate between orange

and green (pull the camera towards

you to see the LED lights).

quick installation guide

PAGE 1
quick installation guide Download the Tend Baby app to your iOS or Android device. Find the perfect spot for your new Kodak Baby Monitoring System & plug it into an outlet using the enclosed power adapter. Press the power button on the right side of the Base Unit to turn it on. You’ll hear “power on”. Wait up to two minutes for the camera to go into setup mode.
PAGE 2
05 Go to the Wi-Fi settings on your mobile device and connect to the Wi-Fi network labeled CFH-BVA10XXXX (last 4 digits of the MAC ID). 06 Launch the Tend Baby app to allow the camera and your mobile device to sync. Follow on-screen instructions to complete Camera and App setup. 07 The Base Unit and the Parent Unit come pre-paired for your convenience.
PAGE 3
Baby Monitoring System CFH-BVA10 WE’RE HERE TO HELP Learn more about the KODAK Baby Monitoring System and Tend Baby app at kodak.tendinsights.com The Kodak trademark and trade dress are used under license from Kodak Apple, iPad, and iPhone are trademarks of Apple, Inc. Android is the trademark of Google Inc. © 2015 Tend Insights, Inc. All rights reserved.
PAGE 4