Owner`s manual

Page 33
Yosemite Wood Stove
R
7004-187I December 20, 2011
1. Remove all ash from rebox, and extinguish all hot embers
before disposal into a metal container.
2. Remove ceramic blanket and bafe together.
3. With a 3/16” Allen wrench, remove the front manifold tube
retainer bolts on the air channel under the end of the front
tube. Figure 33.1.
NOTE: Soak the bolts with penetrating oil for at least 15
minutes before trying to remove it.
4. To remove manifold tube, slide the tube to one side until one
end is out of its hole. Then, while lifting that end of the ber
board bafe, pull tube up over the air channel and out of hole
at the other end.
5. Slide ber board bafe forward to front of stove and straight
out through door. Figure 33.2.
6. To install the ber board bafe, repeat steps 2 through 4 in
reverse. Be sure the ber board bafe and ceramic blanket
are fully pushed back into position and the blanket is down
at. The front of the blanket should be ush with the front of
the bafe.
E. Bafe Removal & Installation
Ceramic Blanket
Baffle Board
Push baffle board up slightly to
allow room to turn the handle
Baffle Board
Figure 33.2
Figure 33.1