Owner`s manual

Page 22

December 20, 2011

Yosemite Wood Stove

7004-187I

NOTE: When the speed control is turned clockwise, it will

click on to high speed. Turn the speed control clockwise

to decrease the speed. At full clockwise, the blower

should blow gently, but should not stop.

1. With the stove plugged in, turn the speed control knob

to slow (full clockwise).

2. With a small screwdriver, adjust the blower speed by

turning the adjustment mechanism through the hole on

the side of the speed control.

3. Adjust the speed so the blower runs slowly, but does

not stop. Turn clockwise to slow the blower and

counterclockwise to increase the speed.

*Theblowerspeedcontrolforthisunitisadjustedatthe

factory,andnormallydoesnotrequirefurtheradjustment.

B. Adjusting The Blower Speed Control

*If Necessary

A. Door Handle Assemblies

Fiber Handle

Handle

Lock Nut

Door Cam Latch

Spacing

Washers

Neoprene Washer

Figure 22.1 - Front Door Handle Assembly

Figure 22.2 - Side Door Handle Assembly

1. Install washer on door handle shaft.

2. Slide door handle through door.

3. Install additional washer(s) as needed.

4. Install door cam latch and locknut.

Caution! Do not overtighten locknut. Door handle

needs to move smoothly.

5. Install ber handle turning clockwise to secure it to

door handle shaft.

Appliance Set-Up