Owner`s manual

Page 13
Yosemite Wood Stove
R
7004-187I December 20, 2011
Converting Collar For Rear Vent Installation
1. Lift off cast top. Remove 4 Phillips head screws from the
heat shield. Discard heat shield and save the screws.
Figure 13.1.
2. Remove 4 Phillips head screws from the rear shield, 2 on
each side, lift shield off and set aside. Figure 13.4.
3. Remove 1 bolt from each side of the flue transition.
and retrieve nuts attached to bolts. Use 3/8" and 7/16"
wrenches. Figure 13.2.
4. Turn vent to horizontal position. Inspect sealant to ensure
a leak free application. Figure 13.3.
5 Manually snap off the knock-out section and discard. See
white outline in Figure 13.1.
6. Re-attach the rear shield on both sides.
7. Position the bracket (found in the component pack inside
the rebox) over the opening on the rear shield. Use 2
screws removed in Step #1 to secure the bracket. Figure
13.4.
8. Place cast top on the unit.
Discard Heat Shield
Knock Out
Section
Figure 13.2
Attach
bracket
to rear
shield
Bracket
2 screws on
each side
Figure 13.1
C. Horizontal Flue Heat Shield
Required Accessory Part: HTSHLD-7006
Place horizontal ue heat shield over rear shield as shown in
Figure 13.5. Secure with the remaining 2 screws removed
in Step #1 under Reversing Flue Collar.
Secure
Horizontal Flue Heat
Shield
The ue collar is reversible for either a top or rear venting
installation. Accessory Horizontal Flue Heat Shield, Part
HTSHLD-7006, is required in rear vent installations. The
appliance is shipped with the ue collar in the top vent posi-
tion.
B. Reversible Flue Collar
Tools Required: Phillips head screwdriver; 3/8" and 7/16"
wrench
Figure 13.3
Figure 13.4
Figure 13.5