Owner`s manual

Page 6
7051-158
April 9, 2009
R
EDGE 60 Pellet Fireplace
R
R
Horizontal Installation
1. Remove the ue collar and orange gasket from the com-
ponent pack. Push out the 6 slugs in the gasket.
. Remove the rear cover plate. Save screws and plate for
later re-attachment.
. Place the orange ue gasket over the locating pins on
the exhaust ue transition on the back of the replace.
Figure 35.2 on page 35.
4. Position the ue collar over the gasket and secure in
place. Figure 36.5.
5. Position the rear cover plate,secure in place. Figure 36.6.
6. Before placing the pipe over the ue collar, liberally sili-
cone the end of the ue collar with RTV 6500 Hi-Temp
silicone about 1-1/ inches (8mm) wide.
7. Drill holes through the pipe walls directly into the ue
collar one on each side, 180 degrees apart. Screw the
pipe to the ue collar with  screws, . Figure 36.7.
Flue Collar
Pipe
Liberally silicone
all around flue
collar before
inserting into pipe
Top Cover Plate
Vertical Installation (Cont’d)
Figure 36.1
Locating Pin
on Each Side
Drill Holes for Screws
above Locating Pins
X
Figure 36.2
Insert assemblied pipe
and flue collar through
top of outer can and over
gasket.
Secure in place
with 4 screws
Figure 36.3
Attach rear cover plate with hole
at the top and secure in place.
Secure top cover
plate in place.
Figure 36.4
Flue Collar in Horizontal Position
Locating Pins each Side
Figure 36.5
Rear Cover Plate
Installed with Hole
at the Bottom
Figure 36.6
Liberally silicone flue collar
before placing pipe over collar.
Secure pipe to flue collar with 2
screws, 180 degrees apart
Figure 36.7