Owner`s manual

Page 6
7051-158
April 9, 2009
R
EDGE 60 Pellet Fireplace
R
R
C. Frame the Fireplace
Figure 26.1 shows typical framing using combustible materials (x4 lumber shown).
• Framing across the top of replace must be above top standoffs.
• See page 33 for detailed information regarding sub-oor material requirements.
Figure 26.1 - Framing the Fireplace
A B* C** D
inches 
7-1/ 0 8-1/4 7
mm 699 762 972 178
*
If interior of chase will be drywalled, add the thick-
ness to this measurement.
**
Adjust header height for a raised platform under
replace, Taking into consideration the maximum
height allowed for loading fuel into the hopper.
B
C
A
Header MUST NOT
be notched!
D
D = extra space needed
for securing fireplace to the floor
and for outside air connection if
it is installed on side of fireplace
See Section 8 for outside air locations.
Outside Air is REQUIRED for all installations.