Owner`s manual

Page 0
7051-158
April 9, 2009
R
EDGE 60 Pellet Fireplace
R
R
ISSUES SOLUTIONS
1. Metallic noise
1. Noise is caused by metal expanding and contracting as it heats
up and cools down, similar to the sound produced by a furnace or
heating duct. This noise does not affect the operation or longevity
of your appliance.
. Ash buildup on glass
. This is normal. Clean the glass.
. Glass has turned dirty
. Excessive build up of ash. The lower burn settings will produce
more ash, the higher burn settings produce less. The more it burns
on low the more frequent cleaning of the glass is required.
4. Fire has tall ames with black tails and is lazy
4. The ame height adjustment needs to be reduced or the repot
needs cleaning. Heat exchanger & combustion blower needs
cleaning.
5. Excessive smokey start-up
5. Either the repot is dirty or there is too much fuel at start-up and not
enough air.
6. Large ame at start-up
6. This is normal. Flame will settle down once the re is established.
Some smoke is normal.
7. Mechanical Noise
7. The oor of the repot in the auto-clean system may make some
noise as it scrapes the ash into the ash pan.
NOTICE: Odors and vapors are released during initial operation due to the curing of high tem-
perature paint. Open windows for air circulation. Ordors may be irritating to sensitive individuals.
4
Troubleshooting for Homeowner
A. Frequently Asked Questions