Owner`s manual

R
December 1, 2011
Page19
Santa Fe NZ Pellet Stove
7068-114B
D. Igniter Replacement
Thumb Screw
Igniter
Firepot
Figure 19.1
 1. Shutdowntheappliancebyturningdownthethermostat
andlettheappliancecompletelycooldown. Afterthe
appliancehascooleddown,unplugitandremovethe
ashdrawer.
 2. Thewireleadstotheigniterareconnectedtothewire
harnesswith1/4inchmale/femalespadeconnectors.
Disconnect the spade connections and remove the
igniter from the chamber. Loosen thumb screw and
slideigniterout.
 3. Installnewigniterintothechamberandtightenthumb
screw.Re-connectthewirestothe2leadswiththe
spadeconnectors.
 4. Double check that the igniter wires areclear of any
movement, i.e. ash drawer, firepot cleaning rod,
cleaningslideplates,etc.
 5. Re-installtheashdrawerandsidepanelandre-connect
thepower.
E. Bafe & Brick Set Removal
1. FollowpropershutdownproceduresinSection10.
2. The top bafe has a hook on the bottom left side that
restsonthetoplipofthecastbrick.Thereisatabon
the bottom right side that hooks into the side bracket.
Removethetopbafebyrstpullingthebafe forward
untilbackedgedropsdown.Thenslidebafebackuntil
thefrontedgeclearstheshelfthatithadbeenrestingon.
Figure 19.2.
3 . Thetopbafe must be removed beforeyoucanremove
the right and left brick.  Remove the right brick by hold-
ingtoplipofbrickandliftingup,thenpushoutsideedge
back.Slidebricktotherightuntilitisushwiththerebox.
Rotate the inside edge of the brick forward and remove
brick.Repeatforleftbrick.Figure 19.3.
Hook on
left side
Tab on
right side
Remove Right
& Left Brick
Vacuum
Exhaust Area
Right Brick
Removed
Figure 19.2
Figure 19.3
Figure 19.4