Owner`s manual

Page 20
7050-128B
September 3, 2009
Santa Fe Pellet Stove
R
D. Optional Log Set Placement Instructions
Figure 20.1
4 PIECE LOG SET INSTALLATION
OPTIONAL
TOP LOG
Figure 20.2
Figure 20.3
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fi re, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
1. Place the right rear log as shown. There is a notch in the
bottom of the log for clearance for the thermocouple and
thermocouple cover (ceramic protection tube). Figure
20.1.
2. Continue placing the last 3 logs around the fi repot as
show in Figures 20.2, 20.3 and 20.4. Be careful not to
block the drop tube in the back of the fi rebox where pel-
lets feed into the fi repot.
Place the top log over the fi repot. It will be about
2- 1/2 inches (64mm) above the fi repot when in
place. Notice the position of the top log as it rests
on the 3 logs in a stable position to prevent it from
falling into the fi repot.
The charred area on the back of the top log faces
the back, not the front. Figure 20.5.
Drop Tube
Notch
Thermocouple
Cover
Figure 20.4
Figure 20.5