Installation manual

6/27/2014 7019-230A 15

Santa Fe Pellet Insert

NOTE: In Canada, where passage through a wall or partition of

combustible construction is desired, the installation shall conform

to CAN/CSA-B365.

Figure 15.1

Fire Risk.

Inspection of Chimney:

• Masonry chimney must be in good condition.

• Meets minimum standard of NFPA 211

•

Factory-built chimney must be a minimum 6 inch

(152mm) UL103 HT.

WARNING

CAUTION

Never draw outside combustion air from:

• Wall, ﬂ oor or ceiling cavity

• Enclosed space such as an attic or garage

NOTE:

• Illustrations reﬂ ect typical installations and are FOR DESIGN

PURPOSES ONLY.

• I

llustrations/diagrams are not drawn to scale.

• Actual installation may vary due to individual design

preference.

Outside Air through Rear

Wall (Horizontal)

NOTE; Use metal plate around

exhaust vent pipe and seal all

edges with non-flammable insu-

lation such as fiberglass, mineral

wool or ceramic.

Do not use high temperature

caulking materials to seal any

edge to prevent furture service-

ability.

Figure 15.1

5 Venting Systems

A. Full Reline With Outside Air - Horizontal