Specifications

38 Quadra-fire • QV32B, QV36B • 2013-900 Rev. F • 9/06
Placing the Ember Material
Ember material is shipped with this gas fireplace. The bag
labeled Glowing Ember (050-721) is standard glowing ember
material. To place the ember material:
• Remove the door by lifting it up and away from the unit.
• Unlatch the latches at the top and bottom of the glass.
• Remove the glass from the unit (see Figure 39).
Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the instructions that accompany the
logs. Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
GLASS SPECIFICATIONS:
QV36B TEMPERED
QV32B TEMPERED
___________________________________________
___________________________________________
Shutter Settings
NG LP
QV32B 1/4” FULLY OPEN
QV36B 1/4” FULLY OPEN
Village Collection fireplaces manufactured with tempered
glass may be installed in hazardous locations such as bath-
tub enclosures as defined by the CPSC. The tempered
glass has been tested and certified to the requirements of
ANSI Z97.1-1984 and CPSC 16 CFR 1202. (Safety Glazing
Certification Council SGCC # 1595 and 1597. Architec-
tural Testing, Inc. Reports 02-31919.01 and 02-31917.01.)
This statement is in compliance with CPSC 16 CFR Sec-
tion 1201.5 “Certification and labeling requirements” which
refers to 15 USC 2063 stating “…Such certificate shall ac-
company the product or shall otherwise be furnished to
any distributor or retailer to whom the product is delivered.”
Some local building codes require the use of tempered
glass with permanent marking in such locations. Glass
meeting this requirement is available from the factory.
Please contact your dealer or distributor to order.
Figure 39. Glass Assembly
LATCHES
(BOTH TOP AND
BOTTOM)
GLASS
ASSEMBLY
• Place dime size pieces of ember material about 1/2
inch apart near port holes in burner top. Do NOT press
embers into burner ports. Cover the top of the burner
with a single layer of ember material. For best perfor-
mance do NOT place embers on the ports at the rear
of the burner (see Figure 40).
Figure 40. Placement of the Ember Material
EMBER MATERIALS
• Save the remaining ember materials for use during fire-
place servicing. The bag of embers provided is suffi-
cient for 3 to 5 applications.
• Reinstall and latch the glass and door on the unit.
CAUTION: THE GLASS MUST BE SECURELY LATCHED
BEFORE OPERATING THE UNIT.