Specifications

QFP 30 Direct Vent Gas Fireplace
Page 34 03/21/01 #250-6120
LIGHTING INSTRUCTIONS
LIGHTING INSTRUCTIONS
A. This appliance has a pilot that must be lit manually. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING, smell around the appliance areas for gas. Be sure to
smell next to the oor because some gas is heavier than air and will settle
on the oor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance
Do not touch any electric switch; do not use any phone in your building
Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
If you cannot reach your gas supplier, call the re department.
C. Use only your hand to push in or turn the gas control know. Never use tools. If the
knob will not push in or turn by hand, don’t try to repair it, call a qualied service
technician. Force or attempted repair may result in a re or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a
qualied service technician to inspect the appliance and to replace any part of the
control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1 STOP! Read the safety information above on these instructions.
2. Set the thermostat to the lowest setting ( if applicable) and turn off the switch
at the control panel.
3. Disconnect power from appliance.
4. Remove fascia.
5. Open the door of the appliance with spring latches located at the top and
bottom of the door.
6. Wait ve (5) minutes to clear out any gas. Smell for gas, including near the oor.
If you smell gas, STOP! Follow “B” of the safety information above. If you don’t
smell gas, go to the next step.
7. Push gas control knob in and turn to “PILOT” position. NOTE: Knob cannot be
turned from “PILOT” to “OFF” unless knob is pushed in slightly. Do not force.
8. Press down on the gas control knob in “PILOT” position and simultaneously
press piezo igniter on the control panel. (This may take many repetitions for
lighting.)
9. The pilot should be visible through the door.
10. After the pilot is lit, continue holding control knob down for Approximately 30
seconds. Release knob and it will pop back up.
Pilot should remain lit. If it goes out, repeat steps 5 through 9.
If the knob does not pop up when released, stop and immediately call your service
technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and
call your service technician or gas supplier.
11. Close appliance door.
12. Turn gas control knob to “ON”.
13. Turn burner switch on the control panel to “ON”. If thermostat is to be used, leave
switch in “OFF” position and set the thermostat to desired setting.
14. Reconnect electrical poser to appliance.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Push in gas control knob slightly and turn clockwise to “OFF position.
Do not force.