Specifications

QFP 30 Direct Vent Gas Fireplace
Page 30 03/21/01 #250-6120
NOTE: Installation of the brick set should be made prior to
the logset, lava rock and mineral wool installation.
1. Remove glass door by releasing the 4 spring latches, 2
at the top of door and 2 at bottom. Remove mounting
screws and clips on right and left top of rebox. See
Fig. 4 for location.
2. Place rear brick behind lip on burner tray against rear
of rebox. Fig. 1
3. Place top brick on top of rear brick and hold into place
with your hand while next brick is installed. Fig. 2
4. With top brick held into place, slide right or left brick
into place along burner tray. Then slide next side panel
into place. Fig. 3
5. Attach brick retaining clips to right and left sides using
mounting screws and clips removed in Step 1. Fig. 4.
LAVA ROCK & MINERAL WOOL
INSTALLATION
1. Pour lavarock around edges of burner tray. Use both bags
supplied with unit. You want a nice even layer of rock.
Take care not to cover up log pins with rock. Fig. 5
2. With about 1/2” pinches of mineral wool, cover burner
pan with even layer. Take care not to block ports on
burner pan.
BRICK INSTALLATION
FIG. 1
FIG. 2
FIG. 3
FIG. 4
FIG. 5
FIG. 6
BRICK, EMBER & LAVA ROCK INSTALLATION