Specifications

QFP 30 Direct Vent Gas Fireplace
Page 12 03/21/01 #250-6120
LP CONVERSION, CONT.
LP CONVERSION
1. Remove glass frame by unlatching door in each corner.
Fig. 1.
2. If installed, remove logs, embers, and lava rock. retain
these items.
3. Remove burner tray with Phillips screwdriver. There are
(7) screws in tray, (3) in front and (2) on each side. Lift
tray up and out. Fig. 2 & 3.
4. With Phillips screwdriver, remove (2) screws on burner
pan. Remove pan by lifting up on right hand side of
burner and pulling to the right. Take care not to bend
air shutter rod. Fig. 4.
5. Use a 5/8” wrench to remove burner orice and replace
with correct orice for LP. Fig. 5.
6. Remove pilot hood by pulling up on hood. Fig. 6. Then
use a 5/32” Allen wrench to remove pilot orifice and
replace with orice supplied in kit. Fig. 7.
7. Replace all parts in reverse order.
FIG. 1
FIG. 2
FIG. 3
FIG. 4
FIG. 5
FIG. 6
FIG. 7
PULL TO
RELEASE -
2 ON TOP & 2
ON BOTTOM OF
DOOR/GLASS