Owner`s manual

Quadra-Fire • QFI30FB-C, QFI35FB-C • 2221-901 Rev. S • 2/15 24

C. Connecting Vent Pipe

Reference instructions in the termination kit.

• Install the 3-inch ﬂ exible vent pipe(s) down through the

chimney.

• Secure the exhaust ﬂ exible vent pipe to the 3 foot section

stainless steel flexible vent pipe using the factory-

installed 3-inch collar in the stainless steel section of

pipe (see Figure 8.1).

• Secure the stainless ﬂ exible vent pipe to the exhaust

starting collar on top of the appliance with three screws.

• Use 3 screws to attach the section of inlet air vent to

the inlet collar on the collar slide plate. See Figure 8.1.

NOTE: The collar slide plate may be removed from

appliance to aid installation.

Figure 8.2

CUT AND BEND

FLASHING AS NEEDED

TO FIT CHIMNEY

SEALANT

ADHESIVE

• Trim chimney top plate to minimize excess overhang or

bend over ﬂ ue tile (see Figure 8.2).

• Place 3/8 inch bead of silicone (300ºF minimum

continuous exposure rating) on ﬂ ue tile top.