Owner`s manual

Page 30

7036-135B

January 17, 2007

Mt. Vernon Pellet Insert (AE)

E. Glass Replacement

• Glass is 5mm thick high temperature heat-re-

sistant ceramic glass.

• DO NOT REPLACE with any other material.

• Alternate material may shatter and cause

injury

WARNING

Figure 30.1

a. Swing open the face and remove door from the appli-

ance by lifting door off of hinge pins and lay on a ﬂ at

surface face down.

b. Using a Phillips head screw driver, remove 4 screws 2

on the top and 2 on the bottom. Remove metal bracket

and then remove the glass. Figure 30.1

c. Replace with new glass with gasket.

d. Re-attached metal bracket with 4 screws.

e. Re-install door over hinge pins and close face.

Remove 4 screws

Glass with Gasket

Metal Bracket