Owner`s manual

Page 28
7036-135B
January 17, 2007
R
Mt. Vernon Pellet Insert (AE)
10. Cleaning Exhaust Blower - Requires No
Lubrication
• Frequency: Yearly or as needed
• By: Qualifi ed Service Technician
• Task: Contact your local dealer.
9. Cleaning the Glass
• Frequency: As needed
• By: Homeowner
• Task:
a. Appliance must be completely cool before cleaning
glass.
b. Use a damp paper towel or any nonabrasive glass
cleaner. Wipe off with dry towel.
Handle glass assembly with care.
When cleaning glass door:
• Avoid striking, scratching or slamming
glass.
CAUTION
• Do NOT clean glass when hot.
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white fi lm.
Refer to maintenance instructions.
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
WARNING
11. Cleaning Convection Blower - Requires No
Lubrication
• Frequency: Yearly or as needed
• By: Qualifi ed Service Technician
• Task: Contact your local dealer.
13. Soot and Fly Ash: Formation & Need for Removal
in Exhaust Venting System.
• Frequency: Yearly or as needed
• By: Qualifi ed Service Technician/Homeowner
• Task:
The products of combustion will contain small particles
of fl y ash. The fl y ash will collect in the exhaust venting
system and restrict the fl ow of the fl ue gases. At start-up
if there is incomplete combustion, or if there is a shut-
down or incorrect operation of the appliance it will lead
to some soot formation. This will collect in the exhaust
venting system.
The venting system may need to be cleaned at least once
a year or more often depending upon the quality of your
fuel or if there is a lot of horizontal pipe sections. Ash will
build up more quickly in the horizontal sections.
12. Door Latch Inspection
• Frequency: Periodically
• By: Homeowner
• Task:
The door latch is non-adjustable but the gasketing between
the glass and fi rebox should be inspected periodically to
make sure there is a good seal. If the gasket is frayed or
damaged, replace with a new one.