Owner`s manual

Page 18
7036-135B
January 17, 2007
R
Mt. Vernon Pellet Insert (AE)
C. Hearth Support
Included in Kit: (1) bottom, (1) trim front, (2) trim sides, (2)
trim extensions
Tools Needed: Phillips head screw driver, measuring
tape, gloves
Figure 18.1
Figure 18.3 - Shown with Cast Panel Set
Basic
Cast
Attach Trim to Base
from underneath
Attach Trim to Insert from
inside Insert.
Install Front Trim Last,
Corner Overlap Side
Trim Pieces
Cast trim
is 5 inches
high
Basic Trim is 3 inches high
Location of Latch
for Removing
Cast Sides
D. Removal of Cast Sides
You will need to remove the cast sides in order to install
the panel and trim set.
1. There is a latch on the back side of the cast side in the
middle of the top opening of the cast side as indicated
in Figure 18.3.
2. Place your fi ngers inside the opening and squeeze
the latch. The side can now be pulled toward you and
removed. Place on a protective surface so as not to
damage the fi nish.
3. To replace the side, set the bottom in fi rst. Squeeze
the latch in an open position. Place the cast side into
position and then release the latch. The latch hooks
onto a bracket to hold the side in place.
1. Remove contents from box and lay on protective surface
to avoid scratching the paint.
2. Lay front and sides face down. Bend the tabs down
toward the inside. Figure 18.1.
3. The side pieces are shipped fl at. It is must easier to fl ex
the sides into a bowed position before installing.
4. Lay the cast bottom face up. Attach the 2 sides FIRST and
then the front piece. Figure 18.2.
5. Turn the cast bottom right side up and attach the panel
extensions. Note the alignment hole.
6. Attach cast footers.
7. Place the assembled hearth support under the insert.
8. Open the door and attach the hearth support to the insert.
There are 9 attachment holes.
Bend tabs down. Shipped
flat from the factory.
Figure 18.2