Owner`s manual

October 27, 2014 7036-187C 29
MT. VERNON AE INSERT
6 Service Parts Replacement
Baffle
Latches
Insert flat head screw driver into “V”
section and push down and the bottom
of the latch will fall forward off of post
Locating ears - 1 on
each side. Fit behind
bottom edge.
Figure 29.1
A. Baffl e Removal
a. The appliance must be in complete shutdown, com-
pletely cool and the exhaust blower off.
b. Open door.
c. The baffl e is located at the top inside of fi rebox.
d. Remove baffl e by placing a fl at head screw driver into
the slot of the latches located in the upper corners and
push down. The bottom of the latch will fall forward off
of the post. Lift the baffl e up and then out toward you.
Figure 29.1.
e. To replace the baffl e, place the 2 locating ears behind the
bottom edge and tilt the baffl e up and into place.
f. The baffl e must be centered in the fi rebox before latch-
ing it in place. If it is not centered the latch is trapped
between the baffl e and side of the fi rebox instead of
latching properly.
g. The bottom of the latches will fi t over the posts. Push the
top of the latch forward to lock latch into place.
WARNING
Cast iron is a very heavy material. The baffl e is
made of cast iron and therefore is heavy and awkward
at times to maneuver. Clear and prepare your work
area before you begin.
Remove 4 screws
Glass with Gasket
Metal Bracket
Figure 29.2
• Glass is 5mm thick high temperature heat-resistant
ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause injury.
WARNING
B. Glass Replacement
a. Swing open the face and remove the door from the
appliance by lifting the door off of the hinge pins and lay
on a fl at surface face down.
b. Using a Phillips head screw driver, remove 4 screws, 2
on the top and 2 on the bottom. Remove metal bracket
and then remove the glass. Figure 29.2.
c. Replace with new glass with gasket.
d. Re-attach metal bracket with 4 screws.
e. Re-install door over hinge pins and close face.