Owner`s manual

January 29, 2014 7034-276 17
MT. VERNON AE
b. Flame Height Adjust
FLAMEHEIGHTADJUSTisusedtoadjustameheight(fuel
feedrate)forspecicinstallationandfueltype.Thedealer
will usually adjust this ifnecessary on installation and can
adviseonspecicsettingsforaparticularapplication.
Figure 17.1
d. Temperature Calibration
TEMPERATURE CAL is used to calibrate the tempera-
ture on the wall control. If for some reason you feel the
wall control is not accurately reading the temperature you
cancalibrateittoathermostatthatyouknowisaccurate.
PresstheUP/DOWNbuttonstodesiredtemperature.
c. Temp Differential
TEMPERATURE DIFFERENTIAL is used to change the
setdefaulttemperaturedifferential.Thissetshowfarbe-
low the set point the wall control allows the room tempera-
turetofallbeforetheapplianceturnsbackon.Itisusually
set at time of installation.
Figure 17.2
TEMPERATURE CAL
71.6
O
F
Cal Adj:
-13
DONE SET
Figure 17.3
e. Properties
PROPERTIESshowstheversionofsoftwareforthecontrol
boardandwallcontrol.Ifyouareplacingaservicecallwith
yourdealer,theymayaskyoutogotothisscreenandread
them the information under “WC” and “SC”.
WC
SC
CB
CV
40h
6Bh
000
000
UFTI: 029
Rev: 004
TC: -28
PROPERTIES
DONE
Figure 17.4
f. Elevation
ELEVATION allows you to adjust the appliance to your
specicelevation.PresstheUP/DOWNbuttonstoselect
your elevation. The message in the center will change
betweenNORMALandHIGH.IfyouselectHIGH,itwill
replace the normal fuel tables with specic high fuel ta-
bles.YouMUST select a fuel type after selecting HIGH.
Please note that changing the elevation will delete any
customornewfueltableloadedintotheappliance.You
mustconrmyourchoiceontheCONFIRMELEVATION
CHANGE screen. This allows you to reverse your deci-
sion if necessary. Figure 17.6
ELEVATION
Over 4000 FT
Normal / High
Up to 4000 FT
DONE
Figure 17.5
CONFIRM ELEVATION CHANGE
YES
Changing elevations will
delete any custom or
new fuel tables loaded into
the stove.
Are you sure?
NO
Figure 17.6
g. Convection Blower Speed
CONVBLOWERSPEEDallowsyoutoadjusttheblower
speedtoyourindividualpreference.PresstheUP/DOWN
buttonstoselectyourblowerspeed.Themessageinthe
centerwillchangebetweenNORMALandQUIET.
NORMALallowstheconvectionblowertoreachmaximum
RPMat135degreesandQUIETat165degrees.
CONV BLOWER SPEED
Normal
Normal / Quiet
Quiet
DONE
Figure 17.7
h. Language Selection
LANGUAGE allows you to select from four different lan-
guages. To select a language scroll down to the last item
ontheUSERSETTINGscreenusingtheDOWNbutton.
Using the UP/DOWN buttons select the preferred lan-
guage and then press Select and then press Done.
LANGUAGE
SELECT
DONE
Français
Norvégien
Suédois
Anglais
Figure 17.8