Owner`s manual

Page34
7014-179D
December 16, 2011
R
CB 1200 Pellet Stove
2. Exhaust Blower Replacement
G. Igniter Replacement
F. Bafe Removal
1. Useproper shut downprocedures to shutdown the
appliance and let it completely cool down and then
unplugitandremovetheashdrawer.
2. Follow instructions to remove the ash pan foundon
page 30.Removetheaccessplatedirectlyaboveit
byremovingthe2screwsjustbelowtheashcatcher.
3. Thewireleadstotheigniterareconnectedtothewire
harnesswith1/4inchmale/femalespadeconnectors.
These wires will pull forward approximately 4 to 5
inches (102mm to 127mm).  Disconnect the spade
connectionsandremovetheigniterfromthechamber.
Loosenthethumbscrewandslideigniterout.
4. Install new igniter into the chamber and tighten the
thumbscrew.Re-connectthewirestothe2leadswith
thespadeconnectors.
5. Remove right side panel and pull wire leads back
towardtherearoftheappliancetotake-upthe4to5
inches(102mmto107mm)previouslypulledout.This
willkeepthewiresoutofthewayoftheashdrawer.
Doublecheck that theigniter wires are clear of any
movement,i.e.ashdrawer,repotcleaningrod,etc.
6. Re-installtheashdrawerandsidepanelandre-connect
thepower.
1. Usepropershutdownprocedurestoshutdownthe
applianceandletitcompletelycooldown.
2. Openrightsidepanelandthenopenthedoor.
3. The2bafesarelocatedatthetopinsideofrebox.
4. Place your hand on the bafe and slide it up and the
bottomedgewillfalldownandthenyoucanliftthebafe
out.Repeatfortheotherside.
Igniter
Igniter Bracket
Thumb Screw
Figure 34.1
Remove existing blower:
a. Usepropershutdownprocedurestoshutdowntheappli-
anceandletitcompletelycoolandthenunplugit.
b. Usean11/32"wrenchornutdrivertoloosenandremove
the (6) nuts holding motor mount plate to the blower
housingonyourstove.
c. Removewasherfrombeneaththeterminalringonthe
groundingwire.
d. Pullmotor/mountingplatefromblowerhousing.
e. Scrapeoffoldgasketingmaterialfromblowerhousing.
Install new blower:
f. Theblowerandblowerhousingisshippedasaunit.It
is necessary to separate them at this point if you are
usingtheexisting blower housing alreadyinstalled on
theappliance:
g. Followsteps2and3above.Discardorsetasidethenew
blowerhousing.
h. Carefullyremovegasketingfromnewhousingandset
ontotheblowerhousing.
Re-install blower to blower housing:
i. Installbloweronhousingensuringthatwiringexitsfacing
the8o’clockposition.Placethewasherandthenthe
groundingwireonnearestmountingplatestud.
j. Usenutsremovedinstepbtosecureblowertohous-
ing.
k. Re-connectwiring(usejumperwireifnecessary).Re-
connectpowersupply.