Owner`s manual

December 16, 2011
7037-135H
Page37
4300 Wood Stove Series (ACC)
R
F. Tube Channel Assembly Replacement
Removing Tube Channel Assembly
1.Removetherightsideshieldbyremoving2screwsinthe
backusingaPhillipsheadscrewdriver.
2.Remove4screwsfromchannelaccesscoverandremove
cover.
3.Locate 2 channel nuts inside of chamber and remove
using a 7/16 socket wrench.  Slide out tube channel
assembly.
NOTE:Soaktheboltswithpenetratingoilforatleast15min-
utesbeforetryingtoremovethem.
Replacing Tube Channel Assembly
1.Sildeonegasketoneachtuberst.
2.Slidethetubechannelassemblyintosideofreboxand
inserteachtubeintothecorrespondingholeinthetube
channelrackstartingwiththebackholerst.
3.Make sure tube channel assembly is ush against the
sideofthestoveandsecurewithchannelnuts.
4.Re-installchannelcoverandsideshield.
Channel
Access
Cover
Channel
Nuts (2)
Side Panel
Tube Channel
Assembly
Channel Cover
Screws (4)
Tube Channel Rack
Remove
2 Screws
Slide one gasket
over each tube
Figure 37.1
NOTE: Service Space
Inordertoreplacethetubechannelassemblyaclearance
of19inches(483mm)isrequiredontherightsideofstove
inordertoremovethetubeswiththestoveinplace.
Ifspaceisnotavailable,thestovewillhavetobediscon-
nectedfromthechimneytoproceedwiththetubereplace-
ment.