Owner`s manual

December 16, 2011
7037-135H
Page23
4300 Wood Stove Series (ACC)
R
B. Leg Kit and Ash Removal Installation
(ARS) for Step Top Uni-Body
DoNOTtilttheunitonthecastironlegs.
• Tiltingcouldleadtopropertydamage.
• Lifttheunituprightandplaceitintopositiononthe
oorprotector.
CAUTION
Laystoveflatonits
backonprotective
paddingorpallet
Insert2bottom
screwsloosely
AshDrawer
LegBrackets
NOTE: The Ash Removal System, must be
installed rst before installing the legs.
Figure 23.1
Figure 23.2
LegMountingBracketsare
packagedinsidefirebox.
LevelingLegsat
oppositecorners
Begin installing the ARS System.
1. Followsteps1through6 onpage 21. Seealso Figures
21.2 and 21.3.
Installing Leg Kit
1. Removelegmountingbracketspackagedinsiderebox.
2. Attach the2bottomscrewsofthemountingbracketsto
thebottomofthestovewith1/4”-20Phillipsheadscrews.
Thesescrewsarelocatedinthecomponentpack.
Leavethebottom2screwsloosesoyoucanslidetheash
panassemblybottomslotsoverthescrewheads.Thisal-
lowstheweightoftheashpantorestonthescrewswhile
youareattachingthetop2screws.Oncetheashpanis
attached,tightenallscrews.Figure 23.2.
3. Looselyassembleboltsintothecornerofthemounting
bracketsforlegattachment.Figure 23.1.
4. Slidelegsontomountingbracketsmakingsurethelegs
areupagainstthebracketandsecurewiththeboltssup-
plied.Therearelevelingboltsin2legs.Theseleveling
legsshouldbeinoppositecorners. Figure 23.1.
5. Carefully stand stoveup and placein desired location.
DoNOTtiltuponthecastironlegs,itcoulddamagethe
legs.
6. Uselevelingboltsonlegstostabilizeandlevelstove.
Finishing the ARS Installation
1. Followsteps1through3 onpage 22. Seealso Figure
22.2.