Owner`s manual

January 10, 2013
7075-166B
Page 21
VOYAGEUR GRAND Wood Insert
R
5
Service Parts Replacement
A. Glass Replacement
(Replace with 5mm ceramic glass only)
1. Ensurethatthereisoutandtheapplianceiscoolto
the touch.
2. Protect a table or counter top with padding or towels.
Protectyourhandsandwearglovestopreventinjury.
3. Remove thedoorwith thebroken glassby lifting the
door up and off of the hinges.
4. Laydoorfacedownonatableorcountermakingsure
thehandlehangsovertheedgesothedoorlaysat,on
a soft surface.
5. Remove the screws from each glass retainer and remove
theglass.(Ifscrewsaredifculttoremove,soakwith
penetratingoilrst).
6. Center the glass with edges evenly overlapping the
opening in the door, (i.e. same space top and bottom,
left and right sides).
7. Replace the glass retainers. Be careful not to cross
thread the screws.
8. Tighten each retainer just a few turns until each is
secured.  Check again for centering of glass indoor
frame.Continuetotighteneachretaineralternately,a
few turns at a time, until the glass is secure. DONOT
OVERTIGHTEN-cancauseglasstobreak.
9. Replace the door on the appliance.
Quadra-Fire appliances are equipped with ceramic super
heat-resistantglass,whichcanonlybebrokenbyimpactor
misuse.
WARNING! Risk of Fire or Injury!
Useonlyglassthatisspeciedinthemanual,DONOT
replacewithanyothermaterial.Glassbreakagewilloccur.
CAUTION!
Handleglasswithcare.
• Inspectthegaskettoensureitisundamaged.
• DoNOTstrike,slamorscratchglass.
• DoNOToperateappliancewithglass&doorassembly
removed.
• DoNOToperatewithglasscracked,brokenor
scratched.
B. Snap Disc Replacement (Cont;d)
Figure 21.1 Snap Disc Location
1. Thegrilleonthebloweraccessassemblyishinged.Swing
the grille downward to expose the 2 screws. Figure 23.1
on page 23.
Blower Controls & Snap
Disc Under Ash Lip
Snap Disc
UNPLUG APPLICE FROM ANY POWER SOURCE
BEFORE REPLACING ANY COMPONENTS
White
Black
White
Black
Black
White
Blower
Snap Disc
Rheostat
Switch
Power Cord
B. Snap Disc Replacement
2. Remove the 2 screws from the blower access assembly
and slide assembly away from the appliance
3.Locatethesnapdiscbracketassemblybehindtheblower
controls on the right side under the ash lip. Figure 22.1
4. Remove the 2 mounting screws in the blower control
bracketandslideassemblytowardsyou.
5. UsingaPhillipsheadscrewdriver,removethe2screws
from the snap disc and lift the snap disc off of the mounting
bracket.Disconectthewiresandreplacewithnewsnap
disc and re-connect the wires.
6. Slide the blower control bracket back into position and
secure with the 2 mounting screws.
C. Wiring Diagram
Figure 21.2