User guide

Configuring PPP and PPPoE

Table 15 Configure a Subscriber Record for PPPoE

Step Task Root Command Notes

Create a PPPoE MOTM

and enable the sending of

it to subscribers.

pppoe motm

Point a subscriber’s

PPPoE client browser to a

specified URL.

pppoe url

For descriptions of the basic tasks needed to configure a subscriber record, see

the document, Configuring Subscribers.

3.2.8 Configure IPCP Netmask Negotiation

To enable IPCP netmask negotiation different from the default, configure

the ppp ipcp negotiate netmask command in global configuration mode and

perform one of the following tasks:

• To reserve an entire subnet range and install the subnet route, configure

the aaa provision route command, without the use-framed-route

keyword.

For example, use the aaa provision router ip-netmask

encapsulation pppoe construct of the command.

• To reserve one IP address and install the subnet route, configure the ppp

ipcp negotiate netmask command and the aaa provision route

command with the use-framed-route keyword.

For example, for PPPoE use the aaa provision route ip-netmask

encapsulation pppoe use-framed-route construct of the

command.

By default, the SmartEdge OS sends an IPCP ConfRej message for netmask

requests without one of these configurations.

3.2.9 Configure MLPPP over PPPoE

To configure MLPPP using PPPoE, perform the tasks described in Table 16.

Enter all commands in global configuration mode.

Table 16 Configure MLPPP over PPPoE

Step Task Root Command Notes

Enable PPP multilink. ppp multilink

Optional. Specify the

endpoint discriminator.

ppp our-options mru

20 64/1543-CRA 119 1170/1 Uen K | 2012-12-04