User guide

Configuration Tasks
3.2.6 Configure a PPPoE-Encapsulated Child Circuit on an 802.1Q PVC
To configure a child circuit on an 802.1Q PVC for PPPoE, perform the tasks
described in Table 14.
Table 14 Configure a PPPoE-Encapsulated Child Circuit on an 802.1Q PVC
Step Task Root Command Notes
1.
Create the parent 802.1Q
PVC and access dot1q
PVC configuration mode.
dot1q pvc Enter this command in port
configuration mode.
Specify the encapsulation type as
multi.
2.
Create the PPPoE-en
capsulated child circuit
and access dot1q child
protocol configuration
mode.
circuit protocol Specify the encapsulation type as
pppoe.
3.
Bind the child circuit with one of the following tasks:
Create an unrestricted
dynamic binding.
bind authenticatio
n
Create a restricted
dynamic binding.
bind authenticatio
n
You must specify the context to
create a restricted dynamic binding.
3.2.7 Configure a Subscriber Record for PPPoE
To configure a subscriber record for PPPoE, perform the tasks described in
Table 15. Enter all commands in subscriber configuration mode.
Table 15 Configure a Subscriber Record for PPPoE
Step Task Root Command Notes
1.
Assign an IP address to
a subscriber record or
profile.
ip address
(subscriber)
2.
Specify a password in the
subscriber record.
password Use the same password
that is specified in the
bind subscriber or bind
auto-subscriber command.
3.
Specify optional attributes in the subscriber record or profile:
Configure routes for
multiple PPPoE sessions.
pppoe client route
1964/1543-CRA 119 1170/1 Uen K | 2012-12-04