User guide

Configuration Tasks
Table 10 Configure an PPPoE-Encapsulated Ethernet Port
Step Task Root Command Notes
1.
Encapsulate the Ethernet
port.
encapsulation
(POS)
Specify the encapsulation type as
pppoe.
2.
Bind the port with one of the following tasks:
Create an unrestricted
dynamic binding.
bind authenticati
on
You must specify the context to create
a restricted dynamic binding.
Create a restricted
dynamic binding.
bind authenticati
on
You must specify the context to create
a restricted dynamic binding.
3.2.3 Configure a PPPoE-Encapsulated ATM PVC
To configure a PPPoE-encapsulated ATM PVC, perform the tasks described
in Table 11.
Table 11 Configure a PPPoE-Encapsulated ATM PVC
Step Task Root Command Notes
1.
Create one or more
PPPoE-encapsulated
ATM PVCs and access
ATM PVC configuration
mode.
atm pvc
Enter this command in ATM OC
configuration mode.
Use the explicit keyword to
create a range of PVCs.
Use the on-demand keyword to
configure a range of PVCs that are
created only when needed.
Specify the encapsulation type as
pppoe.
2.
Bind the ATM PVC with one of the following tasks:
Create an unrestricted
dynamic binding.
bind authentication
Create a restricted
dynamic binding.
bind authentication You must specify the context to
create a restricted dynamic binding.
3.2.4 Configure a PPPoE-Encapsulated 802.1Q PVC
To configure a PPPoE-encapsulated 802.1Q PVC, perform the tasks described
in Table 12.
17
64/1543-CRA 119 1170/1 Uen K | 2012-12-04