User guide

Configuration Tasks
3 Configuration Tasks
To configure PPP or PPPoE perform the tasks in the following sections.
For information about troubleshooting PPP, see the BRAS Troubleshooting
Guide.
3.1 Configuring PPP
This section describes how to configure PPP global attributes, a
PPP-encapsulated port, channel, or ATM PVC, to configure MLPPP on ATM
PVCs or for L2TP subscribers, and to configure a subscriber record for PPP.
3.1.1 Configure PPP Global Attributes
To configure PPP global attributes, perform one or more of the tasks described
in Table 2.
Table 2 Configure PPP Global Attributes
Step Task Root Command Notes
1.
Specify the range with which the SmartEdge OS negotiates LCP option values for
the MRU:
For the router end of PPP
sessions.
ppp our-options mru Enter this command in global
configuration mode.
For the peer at the remote
end of PPP sessions.
ppp peer-options
mru
Enter this command in global
configuration mode.
2.
Enable MRU negotiation. ppp pppoe-large-mr
u
3.
Enable PPP keepalive
checks.
ppp keepalive Enter this command in context
configuration mode with the
check-interval keyword.
4.
Specify timing attributes. ppp keepalive Enter this command in context
configuration mode without the
check-interval keyword.
5.
Specify that a PPP
termination request is
sent to subscribers when
they do not negotiate a
valid IP address during the
IPCP negotiation process.
ppp ipcp disconnect
invalid-ip-address
Enter this command in global
configuration mode.
1164/1543-CRA 119 1170/1 Uen K | 2012-12-04